Rear Knuckle Bushing Removal Tool In Action

Thought I'd post some pics up of the tool I made to remove the stock rubber bushings from the rear knuckle for my car. These need to come out so some polyurethane bushings can go in. I'll post the install of those up when I have it completed.

Here is a pic of the tool I made to remove the rear knuckle bushings

Picture of knuckle


Picture of tool setup on knuckle
Picture of tool in process

End Result. Timed myself and it took 3 minutes to press out.

Parts needed:
1 - ALLOY STEEL THREADED ROD, M12 SIZE, 300MM LENGTH, 1.75MM PITCH (http://www.mcmaster.com/#93325A335)
1 - STEEL COUPLING NUT, M12 SCREW SZ,1.75MM PITCH, 38MM LENGTH, 16MM WIDTH (http://www.mcmaster.com/#93355A115)
1 - BLACK-OXIDE STEEL SQUARE WASHER, 1/2" SCREW SIZE, 9/16" ID, 2" SQUARE (http://www.mcmaster.com/#91128A120)
1 - Pack METRIC TYPE 316 SS LARGE-DIAMETER FLAT WASHER, M12 SCREW SIZE, 37MM OD, 2.7MM-3.3MM THICK (At least 2 required) (http://www.mcmaster.com/#95211A200)
1 - Pack METRIC ZINC-PLATED STEEL HEAVY HEX NUT, CLASS 8,M12 SCREW SZ, 1.75MM PITCH, 19MM W,12MM (At least 2 required) (http://www.mcmaster.com/#90725A725)